DISCONTINUED

    Daystar DS-05A Solar Meter

    The Daystar Solar Meter has been discontinued.



    Solar Meter FAQ

    PV Sensor: The DS-05A solar meter uses a polycrystalline silicon PV cell as the sensor. The cell is mounted on the top end of the meter, perpendicular to the display under a light diffusing lens.

    The sensor responds to a spectrum bandwidth of approximately 0.3-1.1 microns. The meter is intended for outdoor measurements of natural sunlight.

    Meter Calibration: Meters are calibrated on clear days in natural sunlight and adjusted to a reference cell periodically calibrated with pyranometers at Sandia National Laboratories.

    Meters are pointed directly at the sun for calibration. Off-angle calibration is not done. However, empirical data indicate meter-to-meter performance remains consistent up to 40 degrees off-angle from the direct normal. Beyond 40 degrees the readings start to diverge and may reach 10 - 15% when pointed 70-80 degrees away from the sun. The meters are calibrated in groups and records for individual meters are not maintained.

    Care of your Meter: The meters are designed for use in the field but you should treat them as you would your voltmeter; avoid dropping them, do not leave them out in the rain. They are not sealed for continuous exposure to weather. The LCD display may darken if exposed to direct sunlight for a prolonged period.

    Meter Repair: If your meter is damaged or malfunctions, email Raydec (see FAQ) for instructions about repair or return. A repair charge may assessed if your meter is more than one year old.

    Using Your Meter: The Daystar solar meter measures instantaneous solar irradiance and provides the reading in Watts per square meter (Watts/m2).

    You can calculate the total power striking a PV array or module by taking the area of the active PV material and multiplying by the reading from the meter. You can estimate the output power from the PV array for that condition by multiplying by the advertised module efficiency.

    You would have to adjust that value for losses, temperature effects, inverter efficiency, etc., to obtain the actual system output. For more see Using the Daystar Solar Meter.

    Solar Meter Downloads

    Raydec, Inc.

    © Copyright 2024 Raydec, Inc. All Rights Reserved.